Okey, Im now in trouble again after mayor brainfreeze :)

Have routed my homeswitches.
I connected them in parallell.
Brown wire = 24v
Blue wire = gnd
Black wire = signal to bob

If I use this config I get 24v when measuring between black and blue.
If one switch gets close to steel they all light up and the voltage goes to 0 between black and blue.

If I use this paralell connection the bob gets supplied with 24v on the output pin?
Should I instead connect it in series ?
Can't get my mind around this :)

Skickat från min SM-G955F via Tapatalk