New start

**Nr1madman** · 21-03-2018

moooving :D

**JAZZCNC** · 21-03-2018

Another one Lives. Well done that man.

**Clive S** · 21-03-2018

It's always nice to see a machine move for the first time

**routercnc** · 21-03-2018

Nicely done !

**Nr1madman** · 21-03-2018

Thanks for the support! Couldn't have done it without you!!

Tomorrow I'm going to try to verify steps per mm , square the gantry with sensors :)
Dont think I will have time for all limits, all homes, cleaning up the cable jungle in the control cab.

Those things come later, I think spindle is next and then cutting something :D

Skickat från min SM-G955F via Tapatalk

**Nickhofen** · 21-03-2018

Well done man!!! Excellent work!!!

**driftspin** · 21-03-2018

Originally Posted by Nr1madman

moooving :D

Looking good !

Verstuurd vanaf mijn SM-A320FL met Tapatalk

**wallyblackburn** · 21-03-2018

Woohoo!!! Nice!!!

**Desertboy** · 21-03-2018

**Nr1madman** · 22-03-2018

Okey, Im now in trouble again after mayor brainfreeze :)

Have routed my homeswitches.
I connected them in parallell.
Brown wire = 24v
Blue wire = gnd
Black wire = signal to bob

If I use this config I get 24v when measuring between black and blue.
If one switch gets close to steel they all light up and the voltage goes to 0 between black and blue.

If I use this paralell connection the bob gets supplied with 24v on the output pin?
Should I instead connect it in series ?
Can't get my mind around this :)

Skickat från min SM-G955F via Tapatalk