Got ahold of grease nipples for the ballscrews and lithium grease today.

Good news, the slides run much quieter and maybe a little smoother. The ballscrews are definitely quieter!

Bad news, the end seals on the linear bearings leak a bit of grease :( might just be that I tried to fit to much grease :D
I pumped once, slid the axis back and forth for distribution and then pumped again and got leakage. Normal or bad quality bearings?

Worse news, after greasing the ballnuts they spew out dirt and debrie from the seals unto the ballscrews. Should have cleaned them before screwing everything together!
It's not so many screws to dissasemble but the end bearings are pressed on and I don't have a proper remover (don't know the English word for it) damnit!

Skickat från min SM-N910C via Tapatalk