New start

[Nr1madman]

Strange code that what did you create it in.?

Estlcam :)
For my simple needs it feels really intuitive / basic.
Tried cambam some but it just messes with my mind.
For real simple dxf parts I've tried the included cam in uccnc with good results!

Skickat från min SM-G955F via Tapatalk

[JAZZCNC]

Estlcam :)
For my simple needs it feels really intuitive / basic.

Ok that surprises me because I've used Estlcam and the code is usually nice and clean. That thou is strange how it does 180 while ramping.

[Nr1madman]

Ok that surprises me because I've used Estlcam and the code is usually nice and clean. That thou is strange how it does 180 while ramping.

More than likely my fault :D

Skickat från min SM-G955F via Tapatalk