looking for a good 3d printer

[Desertboy]

I think the print was about an hour and 40 minutes, 0.4 nozzle, 0.2 layer, 60C bed 170C hot end.
It's in Taulman Bridge which is lovely to work with compared to standard Nylon 6 filaments.

I found PLA a lot easier to print with than ABS I only recently changed my hot end to an E3d clone so can now print Nylon, etc. The only issue with PLA is it's absorbs water so make sure you store in with silica gel and if it has absorbed moisture an hour in the oven at 80c will sort it out.

I bought 10kg's of ABS when I first bought my printer so I make it work lol but my life would have ben much easier if I had bought 10kg of PLA instead ;)

I find ABS is strong than PLA but there's not a lot in it.