looking for a good 3d printer

[Desertboy]

Ive been looking for the Pi but cant find many options, Any specific ones you know of?


if i make the machine then the motors will be nema 23-24s, might have to go for separate drives any way.

I like the look of the Duet as its all in one but could be an issue if a section stops working. At least separates can be replaced

Nema 23's for a 3d printer unless it's crazy over sized is probably too much like you don't want to use nema 34's on smaller routers, I built my printer with 0.44nm nema 17's (This is at the high end) £10 each from Uk seller and they can whip along at a very fast rate I run my machine a lot slower than I could because I only print occasionally so print time is irrelevant to me and I've found slower speeds are more forgiving.

I only print ABS which is a lot more hassle than PLA which is a joy in comparison.