looking for a good 3d printer

[A_Camera]

So you are saying that if the transmission was provided by a ballscrew with a 16mm Pitch, at 1 to 1 stepping - that i would have the same resolution as if i was using 1/32 microstepping.

Thanks

Alex

1/256 microstepping sounds totally pointless. Even 1/32 sounds too much to my ears. I run my CNC with 1/10 microstepping and I think that's more than enough for both speed and smoothness.

As far as I know, there is no ball screw with 16mm pitch, unless it is very large in diameter. Even 10mm pitch is normally 20-25mm in diameter and is very heavy. Nothing you can run with NEMA17 motors, which are common in 3D printers. My CNC is using 1605 ball screws, which means it is 16mm in diameter and has 5mm pitch.

I think if I build a 3D printer I will use dual ball screws (probably 1004) on the Z with one NEMA23 and belt connecting the two screws. For X and Y I will use direct belt drive.