Hybrid View
-
23-07-2017 #1
CNC Room in Thailand will soon be releasing a new breakout/ motherboard for the UC300ETH, called the UB1.
Specs will be similar to the excellent MB2 breakout board for the ESS.
24V I/O
2 Analog Inputs
2 Analog Outputs
0-10V Speed Control
3 relays
8 input safety circuit
5V isolated inputs for TTL device as well. The users can hook up low voltage MPG.
The UB1 uses 3 ports of the UC300ETH, and provides headers for ports 4 and 5.
Here's a test video of the first prototype.
https://www.youtube.com/watch?v=xZn_jq5LR8A
CNC Room hopes to be ready to start shipping in about 1 month.Gerry
______________________________________________
UCCNC 2022 Screenset
Mach3 2010 Screenset
JointCAM - CAM for Woodworking Joints
-
The Following 2 Users Say Thank You to Ger21 For This Useful Post:
-
23-07-2017 #2
Thanks for the heads up.
It's a while since i had a look at their website. It often seems to be down or unresponsive
I was going to get an mb2 for the uc300eth, but I'll be ordering one of these as soon as they're available.Last edited by Greeny; 23-07-2017 at 11:07 AM.
-
23-07-2017 #3It's a while since i had a look at their website. It often seems to be down or unresponsive
I'll probably be selling my MB2 as soon as I get the UB1.
The MB2 is excellent, and the UB1 should be even better for use with UCCNC.Gerry
______________________________________________
UCCNC 2022 Screenset
Mach3 2010 Screenset
JointCAM - CAM for Woodworking Joints
-
23-07-2017 #4
-
23-07-2017 #5
Loads fine here...
Gerry
______________________________________________
UCCNC 2022 Screenset
Mach3 2010 Screenset
JointCAM - CAM for Woodworking Joints
-
23-07-2017 #6
Ok thanks. Will look into it.
-
23-07-2017 #7
Looks like a nice board Gerry, thanks for the heads up about it, I've sub'ed also.
Not sure what BOB i'm going to use on the current machine i'm building but this one looks very promising..Me
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
anyone using an e-cut 1 mhz usb breakout board
By nobby in forum Control Hardware & SystemsReplies: 10Last Post: 22-10-2018, 11:50 PM -
which breakout board?
By johngoodrich in forum General ElectronicsReplies: 4Last Post: 12-03-2017, 01:54 AM -
routout breakout board
By hazzard in forum Motor Drivers & ControllersReplies: 0Last Post: 20-09-2015, 09:21 PM -
Breakout Board
By Tomnewry in forum General ElectronicsReplies: 2Last Post: 12-12-2013, 07:24 PM -
Breakout Board
By croy in forum Electronic Project BuildingReplies: 10Last Post: 18-08-2011, 07:50 AM
Bookmarks