Quote Originally Posted by JAZZCNC View Post
Horses for courses and You've got the right motors and voltage for that machine. Routers are a different animal so extra torque higher up speed curve helps.
They don't give the speed I was hoping for but that may be down to the resonance I seem to get. It won't help. The inductance for them shows 4.1.
Looking at curves though the torque is equal between the 23 & 34 at 400rpm and over.
The 34 do however give very good acceleration so it's not all bad.
Spindle rpm will likely only allow 600mm/min anyway with 8mm 3flute.

Still an unfinished project.
The machine is more or less built, oil system is in, enclosure has minor snagging issues. Really I just need to finish the coolant system and I'm ready for first chips.