. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 11-08-2017 #14
    dachopper's Avatar
    Lives in PERTH, Australia.
    dachopper
    Last Activity: 29-09-2017 Has been a member for 8-9 years. Has a total post count of 102. Received thanks 2 times, giving thanks to others 1 times.
    I am positive it is not mechanical, if I leave spindle turned off, it does not skip. If I turn spindle on and run job in the air, it jams under no load, and if I try to force it to jam, I can't, so it's 100% electronic interfere
    Last edited by dachopper; 11-08-2017 at 03:30 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 3 users browsing this thread. (0 members and 3 guests)

Similar Threads

  1. Help with Problem X axis Stepper Please
    By howser37 in forum Gantry/Router Machines & Building
    Replies: 53
    Last Post: 09-02-2017, 06:31 PM
  2. Which single stepper for long axis?
    By Boyan Silyavski in forum Motor Drivers & Controllers
    Replies: 0
    Last Post: 24-05-2015, 08:39 AM
  3. Connecting BOB one axis to 2 stepper drivers
    By Noplace in forum General Electronics
    Replies: 8
    Last Post: 10-02-2015, 11:56 AM
  4. Z axis error woes
    By HankMcSpank in forum Machine Discussion
    Replies: 46
    Last Post: 18-02-2012, 03:07 PM
  5. The dreaded task of workshop tidying!
    By m_c in forum Milling Machines, Builds & Conversions
    Replies: 0
    Last Post: 26-03-2011, 08:07 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules