Help connecting servos to breakout board Mach3

[Agathon]

you need to keep on eliminating reasons and i can tell you straight away that i would never use USB-RS232 converter for connecting to servos, or anything. . You need a normal. PC with a normal PCI port and an adapter there. Or even better, a PC with a com port that you could control from bios.


Standard RS-232C RS-422A

specifications
Communications
method
Asynchronous (ASYNC)
Baud rate 2,400 bps
Start bits 1 bit
Data 8 bits
Parity None
Stop bits 1 bit

That above is from your servo drive manual. If baud rate is not set at Com port same same, communication will NOT ever happen



And most of all check that manual https://www.fa.omron.com.cn/data_pdf...8d-u.pdf?id=68 for the proper connection to the drives from the PC side . Check your cabling if is right.


So in other words from page 1-7 seems you need Null Modem Cable https://www.decisivetactics.com/supp...h-serial-cable

OK, got the software to talk to the driver thanks to your diagram Boyan - many thanks. USB-RS232 working well - software thinks it's 422, but I'm not splitting hairs.

Do you have a source for the manual? - it's not the same as the two I already have and may contain more detail. The manuals I have don't show pin numbers for the CN3 port for instance.