Are you glad to have bought a Chinese made CNC Router?

[KeithElcomb]

I had a bad experience with the Chinese 4 Axis machine I just bought. Bed was out of true and the controller was dud on the spindle motor and 4th Axis control.

The seller refused to honour the warranty. This was the seller - denmall850

[Zoprano]

I had a bad experience with the Chinese 4 Axis machine I just bought. Bed was out of true and the controller was dud on the spindle motor and 4th Axis control.

The seller refused to honour the warranty. This was the seller - denmall850

You bought which company?

[KeithElcomb]

You bought which company?

I bought the CNC machine on eBay.

You can see the sellers listing here: -

http://www.ebay.co.uk/itm/4Axis-0-8K...kAAOSwyltZWy99

I have now repaired the faulty controller myself - two wires loose and lack of correct Earth.

The seller refuses to answer requests for assistance.

The Mach3 software supplied is pirated and minimalistic, the manual was rubbish
and there were no setup details for PC control of the spindle.

Sure, it was cheap and not a bad intro to CNC milling, but I will be replacing it as soon as possible, but would not buy from a Chinese seller again.

[cropwell]

I have now repaired the faulty controller myself - two wires loose and lack of correct Earth.

The seller refuses to answer requests for assistance.

You probably know more about the machine than the seller now !

[KeithElcomb]

I managed to squeeze this video from the Chinese on these elusive spindle settings for the 800 watt 3040 4 axis machine.

Would someone, who has a clear understanding of the setup procedures care to cast an eye over this and come up with a clear and easy to follow PDF manual.

I am sure many on here would be eternally grateful.

[KeithElcomb]

WARNING

Before anyone uses this information, sent from the Chinese supplier of my machine, I suggest that you find out what d (p) code 32 means. I have a nasty suspicion that it will lock up the spindle both in PC and manual control.

I assume there is also a d (p) unlock code, but I'm not going to do something I regret.

[Clive S]

WARNING

Before anyone uses this information, sent from the Chinese supplier of my machine, I suggest that you find out what d (p) code 32 means. I have a nasty suspicion that it will lock up the spindle both in PC and manual control.

I assume there is also a d (p) unlock code, but I'm not going to do something I regret.

Why do you have that suspicion? If you do not know then don't use it as a scare for other people.
The vid you linked to seem to be for a 2.2kw vfd and the setting may or not be the same as the for the 800W spindle.

PD13 is the general factory reset. But not a good idea to use it unless you know what you are doing.

Can you say what is the exact problem you have and it would be a good idea to start a separate thread or use your other thread, as this thread was started by Zoprano

[KeithElcomb]

1