Are you glad to have bought a Chinese made CNC Router?

[KeithElcomb]

I managed to squeeze this video from the Chinese on these elusive spindle settings for the 800 watt 3040 4 axis machine.

Would someone, who has a clear understanding of the setup procedures care to cast an eye over this and come up with a clear and easy to follow PDF manual.

I am sure many on here would be eternally grateful.

[KeithElcomb]

WARNING

Before anyone uses this information, sent from the Chinese supplier of my machine, I suggest that you find out what d (p) code 32 means. I have a nasty suspicion that it will lock up the spindle both in PC and manual control.

I assume there is also a d (p) unlock code, but I'm not going to do something I regret.

[Clive S]

WARNING

Before anyone uses this information, sent from the Chinese supplier of my machine, I suggest that you find out what d (p) code 32 means. I have a nasty suspicion that it will lock up the spindle both in PC and manual control.

I assume there is also a d (p) unlock code, but I'm not going to do something I regret.

Why do you have that suspicion? If you do not know then don't use it as a scare for other people.
The vid you linked to seem to be for a 2.2kw vfd and the setting may or not be the same as the for the 800W spindle.

PD13 is the general factory reset. But not a good idea to use it unless you know what you are doing.

Can you say what is the exact problem you have and it would be a good idea to start a separate thread or use your other thread, as this thread was started by Zoprano

[KeithElcomb]

Actually Clive, I believe my comments applicable to anyone thinking of buying a Chinese CNC machine.

Fortunately a very kind member tracked me down and gave me a telephone call. Following his call and setting up my own machine to his instructions, had me up and running very quickly. Had I just followed the video instructions from my Chinese supplier, would have left me with a dead spindle motor, on both manual and PC control. E code LU

I doubt you have actually ever visited the Jinan Blue Elephant CNC Machinery Co., Ltd. factory in Shandong? Which is relevant to Zoprano's thread. Well, I have in 2015 and can vouch that they are first class people.

Having said that I will bow out of this thread.

[Clive S]

I doubt you have actually ever visited the Jinan Blue Elephant CNC Machinery Co., Ltd. factory in Shandong? Which is relevant to Zoprano's thread. Well, I have in 2015 and can vouch that they are first class people.

I also doubt any other member has as well. So if you have been there and have first hand knowledge how come you did not part with it to the OP. A forum is a two way process.

[KeithElcomb]

Can we bring these ping pong posts to a conclusion please and move on.

[ravihotwok]

I have bought a cheap Chinese machine and currently in the process of putting it right. The controller was buggered from the word go, the seller kindly refunded me more than what the controller was worth which I was grateful for. Most of the parts the machine was put together with are fine so far, I have however replaced the motor cables with shielded ones and also purchased a new controller box and software from planet cnc. Not got the machine up and running yet due to time and adding additional parts such as more powerful spindle, limit switches and the actual wiring.

A lot of people slate these machines but at the end of the day I guess you get what you pay for, hopefully I will be able to get the machine up and running in the next few weeks so keep an eye out on my build thread, I will report back onto this thread also with my progress but I do have faith in my little machine :-)

[KeithElcomb]

1