Power supply for anodising?

[Voicecoil]

This I guess is one issue with this ps tbh as it's not selectable the mode and it doesn't say which it's on either.
I'm considering sending it back as I'm certain it's not fit for purpose. I've set a limit of £250 to get something and looking at the Maas suggested above but any pointers would be hugely appreciated. I'll get £110 back for this providing they accept it back. It just doesn't seem close to accurate enough for small scale work like 5-7 sq2 which is a pain as the end caps I do are between them

Sent from my SM-G960F using Tapatalk

OK, then looking at the front panel I guess for constant voltage you turn the current knob way up and set the voltage, and for constant current you turn the volts all the way up and set the current. It seems to me that something like a little lab bacn supply would do you well for you smaller pieces, needn't be too expensive, there's lots like this for example:

https://www.conrad.com/p/basetech-bt...uts-1-x-513812