Power supply for anodising?

[lilvfr400boy]

Couple more bits rattled off getting some consistency now I've got the mounting to the rack setup rite. Have to say this power supply ain't bad tbh. I've ordered a small 30 w 5 amp unit off the bay that's reviewed well as a permanent fixture for the smaller setup as the fusion units coming to the big boy tank. All my amp issues were purely down to how I was attaching the parts ( not enough contact ) in the end ally mig wire 0.8mm wound into coils and pushed tight into the holes has worked perfectly for what I'm doing

Sent from my SM-G960F using Tapatalk

[Boyan Silyavski]

I was attaching my parts using 1mm titanium wire , drill in part somewhere where is not seen 1mm hole and using pliers push the wire. Never had contact problems. I believe it's one of the best way to avoid contact problems when anodizing