. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 08-08-2017 #2
    Zeeflyboy's Avatar
    Lives in Nowhere, United Kingdom.
    Zeeflyboy
    Last Activity: 13-07-2023 Has been a member for 7-8 years. Has a total post count of 440. Received thanks 229 times, giving thanks to others 60 times.
    I'm certainly not a wood expert, but some types of wood will be worse than others - what are you cutting?

    If using a v-point then it just needs to be as sharp as possible, if using endmills then downcut can be useful for a clean edge assuming you can evacuate the chips effectively.

    I assume you've tried just giving it a once over with some fine sand paper to de-burr the edges?
    Reply With Quote Reply With Quote

  2. The Following User Says Thank You to Zeeflyboy For This Useful Post:

« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Syil X4 Plus - E-stop issue
    By Keith-h in forum Milling Machines, Builds & Conversions
    Replies: 8
    Last Post: 03-12-2016, 05:53 PM
  2. Exact stop / CV problems
    By fvfdrums in forum Gantry/Router Machines & Building
    Replies: 0
    Last Post: 31-08-2015, 01:27 PM
  3. Spindle Stop?
    By manofgresley in forum Spindles & Drive Motors
    Replies: 21
    Last Post: 08-01-2013, 06:37 PM
  4. E-STOP Circuit - will this cause any problems?
    By birchy in forum General Electronics
    Replies: 34
    Last Post: 18-12-2012, 04:35 AM
  5. wiring e-stop button
    By deannos in forum General Electronics
    Replies: 10
    Last Post: 14-01-2012, 11:03 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules