MK1 Steel router build log 1500x800x200

[Nr1madman]

I'm sure you are right about having enough room left. Just concerned that the inwards angled sides will create larger miniscus. It might work the other way also :D

I have been known to be wrong! ;)

Skickat från min SM-N910C via Tapatalk

[driftspin]

I'm sure you are right about having enough room left. Just concerned that the inwards angled sides will create larger miniscus. It might work the other way also :D

I have been known to be wrong! ;)

Skickat från min SM-N910C via Tapatalk

Nr1madman.. Ha yes about being wrong... been there done that



I think you might be right about minicus getting worse when walls lean inward...


Will report on this...


I can still change stuff...
you know what i will.


On the x carriage mounting surface.. this is the spot where extra room is needed...

Grtz..

Bert



Verstuurd vanaf mijn SM-A320FL met Tapatalk

[Nr1madman]

Nr1madman.. Ha yes about being wrong... been there done that



I think you might be right about minicus getting worse when walls lean inward...


Will report on this...


I can still change stuff...
you know what i will.


On the x carriage mounting surface.. this is the spot where extra room is needed...

Grtz..

Bert



Verstuurd vanaf mijn SM-A320FL met Tapatalk

If the meniscus should interfere with wide bearings then it's very easy to file the meniscus down. Im just worried that there will be much waste as the epoxy is quite expensive :D

Skickat från min SM-N910C via Tapatalk

[driftspin]

If the meniscus should interfere with wide bearings then it's very easy to file the meniscus down. Im just worried that there will be much waste as the epoxy is quite expensive :D

Skickat från min SM-N910C via Tapatalk

yes its expensive... some 75 euros for +/- 3kg.. its cheapest i could find with good properties and tropical hardner...

need to put a heater in the shop because of this now

grtz Bert

Verstuurd vanaf mijn SM-A320FL met Tapatalk