Best cheap Spray Paint Guns for DIY CNC builder or small workshop

[Boyan Silyavski]

Phill, are you high or sth? "I DARE YOU..." , "It is IMPOSSIBLE to disassemble...". Do you think me for a fool to recommend something in forum which i have not tested at least an year/in fact 3years/. Or you missed to read my other gun is 400euro paint gun, so i have a base to compare.

If i have to explain you how to disassemble a screw, even if its stuck, then this is not the exact place me thinks. Its a CNC forum, not "Fix it at home". Anyway if some people were drinking Coca Cola instead of stronger liquids, they will know the answer, at least for steel screws.


Firts of all you dont need to disasemble the back part to clean the needle. The needle is cleaned when you disassemble the nozzle. In fact you need to do that every couple of times of use, but not always, if you clean the gun using water or the respective thinner, right after use. Fill can with thinner, spray a bit and then with your finger stop air from nozzle. What happens then its bubles start inside the gun and go oput back from ca, that cleans pretty well the needle without dissassembly. Though i always dissassemble when using 2k paint.

I use these guns daily without any problems or need for more expensive guns. Even painted my car with the bigger one. So why dont you take a step back, find a good brand tool like Stanley and unscrew it. With crappy tools there may be a problem if you push too much.