Hello from Waterlooville, Hampshire

[AlexDoran]

Alex - Meeting Chester tomorrow. Are you interested to meet at some time?

Sure am, maybe you guys can pop down to the factory at some point, could show you the two big CMS machines, the one im building and my 3D Printers etc :)

Factory is in Farlington PO6 1SD.

Thanks

Alex

[WRandall]

Hello you lot, i'm also a new member based in Portsmouth (i've got a workshop at Trafalgar Wharf) looking to connect with more experienced CNC'ers.

I've got a 2nd hand chinese DM-1212 which is giving me problems with a dead axis. Also want to convert it over to Mach3, so i'd love to pick a few brains!

Best,

Will

[AlexDoran]

Hi Will,

What Axis is dead? Did you try swapping the motors or Stepper Driver to see which is causing the fault (if it is either of those).

Alex

[Leadhead]

Will - Happy to pitch in if you need some help

[WRandall]

Cheers Leadhead, should i post up some pics of the drivers? Maybe you could advise on whether i need to replace them with different drivers and board in the pc to get me back to running on Mach3. NCStudio is no fun at all :)

[Crazy L]

Hi Chester

Welcome to the forum, looks like you've settled in well. I don't post here often as I don't currently spend a lot of time with my cnc due to other commitments. However, I see you guys have all met. I'm in Havant and feel left out

haha.

[WRandall]

Cheers the reply Alex! Yeh i've swapped the jumpers from the Y over to the x driver and i get movement on the Y that way. So i've got motion on X,Y,Z motors, just the y-allocated driver is showing a fault and can't drive any of the motors with it.

[AlexDoran]

Cheers the reply Alex! Yeh i've swapped the jumpers from the Y over to the x driver and i get movement on the Y that way. So i've got motion on X,Y,Z motors, just the y-allocated driver is showing a fault and can't drive any of the motors with it.

Hi Will,

Ok good start, Pics of the drivers would be helpful, do you mean the driver has a flashing Red LED or something when you say it is showing fault?

Not sure what drivers you have, but the AM882 Leadshine drivers i have flash a red LED if any of the vital connections aren't detected / wired incorrectly.

Thanks

Alex

[Leadhead]

Will - If you are still in trouble. I can pop in next week with a spare driver and BoB if you think it would help.

[WRandall]

And thanks Lead, that would be AMAZING. Have PM'd you with my number. Anytime convenient to you, i'll be there with bells on.