Hello from Waterlooville, Hampshire

[WRandall]

Cheers the reply Alex! Yeh i've swapped the jumpers from the Y over to the x driver and i get movement on the Y that way. So i've got motion on X,Y,Z motors, just the y-allocated driver is showing a fault and can't drive any of the motors with it.

[AlexDoran]

Cheers the reply Alex! Yeh i've swapped the jumpers from the Y over to the x driver and i get movement on the Y that way. So i've got motion on X,Y,Z motors, just the y-allocated driver is showing a fault and can't drive any of the motors with it.

Hi Will,

Ok good start, Pics of the drivers would be helpful, do you mean the driver has a flashing Red LED or something when you say it is showing fault?

Not sure what drivers you have, but the AM882 Leadshine drivers i have flash a red LED if any of the vital connections aren't detected / wired incorrectly.

Thanks

Alex

[Leadhead]

Will - If you are still in trouble. I can pop in next week with a spare driver and BoB if you think it would help.

[WRandall]

And thanks Lead, that would be AMAZING. Have PM'd you with my number. Anytime convenient to you, i'll be there with bells on.

[WRandall]

Think there are photos attached now. Sorry, first time uploading photos to the forum.

Curiously, although nothing else has changed, i'm now also getting a Y Limit alarm on NC Studio. The gantry is nowhere near the limit switch, which is a proximity type.