Threaded View
-
22-09-2017 #4
Last Activity: 3 Hours Ago
Lee I know the board but from what I have read (I think) some of the spindle controllers have a high voltage on them. So I will bow out as I have no experience with that type of controller.I have a dc spindle controller, it has a pot which is connected to a terminal marked 0-10v
My bob has the same terminals
But I am sure some one will chime in and help...Clive
The more you know, The better you know, How little you know
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Spindle Speed Controller Question
By thomashomer1986 in forum Motor Drivers & ControllersReplies: 38Last Post: 31-10-2016, 06:02 AM -
budget diy cnc controller question
By dangerousdave in forum Motor Drivers & ControllersReplies: 54Last Post: 29-08-2014, 01:45 PM -
2m542 source or sink current help?
By Evengravy in forum General ElectronicsReplies: 9Last Post: 12-07-2014, 07:34 PM -
Motor controller next to break out board?
By m_c in forum General ElectronicsReplies: 2Last Post: 17-11-2010, 01:56 PM -
Laptop controller question.
By m.marino in forum Laptops & TabletsReplies: 0Last Post: 07-01-2009, 04:33 PM
Bookmarks