Thread: machineing radius edges
Hybrid View
-
06-10-2017 #1
Im after a few ideas as its come up recently on another project that zeeflyboy very kindly helped me with but now its come up again.
I am trying to make this part not necessarily all on a cnc but however possible and that will be the easiest and cheapest way for a bit of a test.
basically the bit im stuck on is I want to put a 8mm radius on the edges of a bit of 25mm aluminum stock.
im not sure if my current cnc is going to be up for cutting ali but I could give it a try I guess.
What are my best options/methods?
many thanks
-
06-10-2017 #2
If you want 8mm radii and that sharp step in size as in the image you can only do this as a 4 Axis milling job, CNC or Manual.
You think that's too expensive? You're not a Model Engineer are you? :D
-
06-10-2017 #3
Radius cutter, however 8mm may be a bit big for anything but a reasonable size machine with a relatively slow spindle.
I've just checked the first cutter I found (arc euro trade), and an 8mm radius cutter is 24mm OD, with 8mm centre, and a 16mm shank, so a failry substantial machine would be needed.
Removing the bulk of material using a normal endmill and several passes would mean minimal cutting for a final finishing cutting pass.
Other option would depend on how good a radius you want. You could probably get a reasonably OK finish using a ball end mill and multiple passes.Avoiding the rubbish customer service from AluminiumWarehouse since July '13.
-
06-10-2017 #4
But how do you transition from one size to the other with a radius cutter?
I suppose you could clean the transition up with a file?You think that's too expensive? You're not a Model Engineer are you? :D
-
06-10-2017 #5
-
06-10-2017 #6You think that's too expensive? You're not a Model Engineer are you? :D
-
06-10-2017 #7
cool wasn't aware you could get something like that for metal, I was searching for round over bits but only found wood type ones. I may be able to put that in my x2 mini mill just. I can get away with not having the step for the prototype . I guess the best way to get that would be on a 4 axis machine, if anyone thinks they can cnc this if its not going to cost a fortune just drop me a pm
many thanks
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Matching a radius
By kell in forum SolidworksReplies: 2Last Post: 01-12-2015, 11:18 AM -
Machineing horns.
By simonms in forum Machine DiscussionReplies: 0Last Post: 05-02-2015, 11:47 AM -
Hole Radius
By benkat in forum Machine DiscussionReplies: 0Last Post: 03-03-2014, 05:29 PM -
Help coding M14 CCW thread using Welturn on CNC5 using small radius multi pitch tip
By Westy in forum Programmers CornerReplies: 0Last Post: 10-06-2012, 07:59 PM -
Ragged edges
By Minnican in forum Machine DiscussionReplies: 14Last Post: 25-04-2011, 02:32 PM
Bookmarks