Thread: x,y and z axis problems on 3040T
Hybrid View
-
14-10-2017 #1
Hi there, Yes your quite right it has been a mission to get my machine running as it should, but now i can't fault it. mine is a 6040 but try the settings i've figured out.
Port 1 35000 Hz
Motor Tuning;
X Axis 320 1500 400
Y Axis 320 1500 400
Z Axis 400 1500 400
Set The step Pulse & Dir Pulse both to 5
Motor Outputs
screen shot won't upload at the moment but these are the settings i've got
X En (green Tick) 2 3 dir Low Active
y En 4 5 dir Low Active
Z En 6 7 dir Low Active
(Your pins may be different from mine)
When you start Mach3 change the feed rate from 6 to 100, this will give you 1500 mm/m rapid
Hope this helps
Kev
-
14-10-2017 #2
Much appreciated, Kev.
I'll try those settings when I get back from holiday.
Was it the settings that were causing your issues?
Was it trial and error to get to those figures?
Thread Information
Users Browsing this Thread
There are currently 4 users browsing this thread. (0 members and 4 guests)
Similar Threads
-
Zeroing the Z axis has its problems !
By cncezee in forum Artsoft Mach (3 & 4)Replies: 6Last Post: 26-04-2017, 11:12 AM -
Auto zero Z axis problems
By Jumbo in forum Probing, Digitizing & ScaningReplies: 26Last Post: 23-10-2016, 03:00 PM -
Cnc 3040t
By etNick studio in forum Milling Machines, Builds & ConversionsReplies: 7Last Post: 15-11-2014, 10:55 AM -
Z AXIS, big tex blue screen and auto tool sensor Problems
By Tomnewry in forum Artsoft Mach (3 & 4)Replies: 11Last Post: 01-01-2014, 09:01 PM -
Boxford VMC190 Retrofit Problems, axis sounds very rough
By mikegolding in forum Boxford Vertical MillsReplies: 5Last Post: 09-06-2013, 09:11 PM
Bookmarks