Lathe ATC Options?

[Chaz]

There are some on GrabCAD worth looking at.

Effectively you have 4 options.

Manual stuff like Multigrip / Dickson holders.
Gang Tooling, might be worth a look pending what type of stuff you turn.
Turret - rachet / pawl
Turret - pnuematic (or similar) locator function

There is a guy on ebay making very decent looking turrets - sells them for around £500 ish. The only reason I havent bought is that they do max 10mm tools and Id like larger for my lathe.

https://www.ebay.co.uk/itm/Diy-cnc-l...wAAOSwK~RZ-JvI

Not seen him list them like this (in kit form) before.

Spoken to him extensively on whatsup, does this for day job too, seems to know his stuff, worth a look. He also has a gang tool setup for sale but might be too big for a Myford.

[magicniner]

There is a guy on ebay making very decent looking turrets - sells them for around £500 ish. The only reason I havent bought is that they do max 10mm tools and Id like larger for my lathe.

https://www.ebay.co.uk/itm/Diy-cnc-l...wAAOSwK~RZ-JvI

Not seen him list them like this (in kit form) before.

Spoken to him extensively on whatsup, does this for day job too, seems to know his stuff, worth a look. He also has a gang tool setup for sale but might be too big for a Myford.

The turning tool holders look easy to make in a larger size?

[Chaz]

The turning tool holders look easy to make in a larger size?

Perhaps. Ive not seen the kit broken down like this before. It might be where the 'centreline' is effectively which is more challenging.

[magicniner]

Perhaps. Ive not seen the kit broken down like this before. It might be where the 'centreline' is effectively which is more challenging.

Given that they mount in the same holes as drilling and boring tool mounting holes then the centre line is the mounting hole centre line, no challenge! ;-)

[Chaz]

Given that they mount in the same holes as drilling and boring tool mounting holes then the centre line is the mounting hole centre line, no challenge! ;-)

True. Spoken to him, he will likely be able to mod these to go to 12mm. I can then probably make my own later if I want to go to 16 or 20mm tooling.

[magicniner]

Bonus! :D

[Ross77]

I did see that one but put off by the small tool capacity. May have to message him if it can hold 12mm

I'm currently using 16mm tooling with a large QCTP and getting a nice Finnish so don't want to go down to much in case the finish quality is reduced.

would also need to buy all new tooling