Thread: Lathe ATC Options?
Hybrid View
-
01-11-2017 #1
-
01-11-2017 #2
-
01-11-2017 #3
-
01-11-2017 #4
Bonus! :D
You think that's too expensive? You're not a Model Engineer are you? :D
-
01-11-2017 #5
I did see that one but put off by the small tool capacity. May have to message him if it can hold 12mm
I'm currently using 16mm tooling with a large QCTP and getting a nice Finnish so don't want to go down to much in case the finish quality is reduced.
would also need to buy all new tooling
-
01-11-2017 #6
He can mod to 12mm. Anything larger needs new holders done.
-
01-11-2017 #7
Just messaged him so find out soon enough.
looking at the pictures again it does only have 1 pawl on the ratchet so that might limit the force it can take
-
02-11-2017 #8
I use tooling from 6mm through to 25mm+ shank on my Myford Super 7, by milling a relief pocket on the holder side of the shank which just accommodates the bottom lip of the Myford size QCTP holders the ability to use the tool in a larger holder isn't compromised, rigidity isn't reduced to any significant degree and centre height isn't an issue :D
Last edited by magicniner; 02-11-2017 at 10:16 AM.
You think that's too expensive? You're not a Model Engineer are you? :D
-
02-11-2017 #9
Is there a view on what size tool is required? For my Harrison M300, this is a semi beefy home lathe. 12mm almost looks too small. I spoke to Kenny last night (dude selling the stuff) and he says on his Haas CNC lathe, he tried bigger tools (20mm etc) and found that they took up too much space and settled with 16mm. Suppose feeds and speeds are important here too. Most of my turning is alu or softer steels.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
6 wire motor options
By Ross77 in forum Motor Drivers & ControllersReplies: 8Last Post: 27-03-2017, 10:04 AM -
Spindle motors resonable options
By Web Goblin in forum Spindles & Drive MotorsReplies: 15Last Post: 20-11-2016, 03:31 PM -
PC Upgrade Options?
By Chaz in forum General DiscussionReplies: 11Last Post: 31-08-2016, 04:53 PM -
ATC Options?
By Davek0974 in forum Gantry/Router Machines & BuildingReplies: 25Last Post: 14-05-2016, 08:25 AM -
options for 3020 router spindle?
By arborealad in forum Milling Machines, Builds & ConversionsReplies: 3Last Post: 19-11-2012, 10:13 PM
Bookmarks