-
08-11-2017 #1
Hi All.
I’ve recently completed my plasma cutter CNC machine. I’ve managed to home it on Mach 3 and tuned the motors to etc.
I’m a 3D design by trade so creating DXFs is not an issue. I’m stuck with getting the Torch end to raise up after it’s homed by touching the material surface.
I believe this is in the code? Can someone point me in the right direction as to what to do next? Also are there any cheap or free g code generating programmes out there to get this machine to behave the way it’s supposed to.
Many Thanks
Sent from my Moto G (5) using Tapatalk
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Torch Height control
By Bobp in forum General ElectronicsReplies: 21Last Post: 09-12-2019, 04:46 PM -
Port setup to trigger rely for plasma torch
By whensparksfly in forum Artsoft Mach (3 & 4)Replies: 17Last Post: 15-05-2016, 03:13 PM -
Proma elektronika torch height controler any good
By whensparksfly in forum General ElectronicsReplies: 3Last Post: 06-03-2016, 01:17 AM -
TD torch cut height enquiry
By marbles in forum Plasma Table MachinesReplies: 0Last Post: 19-02-2016, 11:57 AM -
Plasma, Mach3, Sheetcam and a Proma Torch height controller..
By Davek0974 in forum Plasma Table MachinesReplies: 2Last Post: 14-04-2014, 03:49 PM
Bookmarks