em806 Senssorless Stall Protection fault

[charlieuk]

Charlie You say various files above.



But here yo are saying on the same line of gcode,

Not sure what this means.

Is it just one axis that is tripping if so can you be a bit more specific as to what is actually going on.
As Neale has suggested does it trip doing fresh air cuts?

The drive is giving the same sensorless stall protection fault on the same file each time if I change the file it faults again but at a different point in the file but is repeatable if you re start the file. The fault causes a external e stop on Mach 3.

Yes the driver trips doing air cuts

Many thanks