Thread: 2.2 KW 3 Phase Induction Motor
-
13-11-2017 #1
A bit of a long shot, does anyone have a Harrison M300 motor that I can buy? Mine has packed up and struggling to find an exact equivalent.
2.2KW (3HP), 4 pole, Star and Delta wiring. 90 sized frame, 24mm shaft.
Thanks
-
13-11-2017 #2
Have you got any machine you've not managed to break? :-)
Inverter Drive have one option available to order- https://inverterdrive.com/group/Moto...4+Pole+1500RPMAvoiding the rubbish customer service from AluminiumWarehouse since July '13.
-
14-11-2017 #3
Nope, seems not.
Thanks, had seen that, bit pricey but OK. Thoughts on installing a higher power motor? I might call a supplier this morning and if the 100 frame motor is only marginally bigger, I might go this route with a new pulley.
Mmmm. That is a face mounting motor, so wont work without mods to the install.Last edited by Chaz; 14-11-2017 at 08:39 AM.
-
14-11-2017 #4
Face mount to flange or foot mount is just a set of parts, the supplier should be able to supply or fit a foot mount kit at minimal cost, my motor supplier has a price for a given spec of motor and supplies foot, face or flange at the same price or the parts to swap it over.
You could share with the class where 3 phase motors are available cheaper if you have a source of good quality units for low prices? :-)
Regards,
NickYou think that's too expensive? You're not a Model Engineer are you? :D
-
14-11-2017 #5
Example - https://www.sdsdrives.com/products/m...2243TECAB3-IE2
Price probably excludes VAT (not sure if the other one does or not). Motor size is OK, frame size a bit larger. So If I can modify a pulley and basically the rest works, this might be the way to go. In which case going with a 3KW 100 frame motor might be OK then?
-
23-11-2017 #6
Managed to get a 3KW motor (100 frame size) from a colleague at work that has some machining stuff.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Hi looking to change 3 phase motor for a 240v, any help much appreciated
By suesi34e in forum Workshop & EquipmentReplies: 21Last Post: 19-01-2017, 01:49 PM -
formula for capacitor on 3 phase motor
By dudz in forum General ElectronicsReplies: 10Last Post: 13-11-2015, 05:37 PM -
Myford 7, 3 phase motor other CNC questions.
By Jconway651 in forum Lathes, Lathe Rebuilding & ConversionsReplies: 23Last Post: 28-01-2015, 10:33 AM -
AC servo motor to replace a 3 phase induction motor on a mill spindle.
By rnr107 in forum Spindles & Drive MotorsReplies: 2Last Post: 23-04-2014, 03:14 PM -
single and 3 phase motor sizing and mounting ?
By Musht in forum General ElectronicsReplies: 5Last Post: 27-10-2013, 09:58 PM
Bookmarks