Thread: A question of Mdf?
Threaded View
-
17-11-2017 #1
Noticed when cutting small tables, the edges (even with a new bit) are very furry.
I know a compression bit is the answer but they are expensive and upper cut spirals have worked in the past.
Is it the quality of the mdf? It seems, the lighter colour it is, the better it cuts (or is that just a coincidence?)
Stuff from Builders yards, Wickes, B & Q seems to waver wildly in quality. Where do you get decent stuff at good prices?
Thread Information
Users Browsing this Thread
There are currently 2 users browsing this thread. (0 members and 2 guests)
Similar Threads
-
NEW MEMBER: Greetings and a question
By Jono in forum New Member IntroductionsReplies: 6Last Post: 04-04-2017, 12:06 PM -
VFD Question
By Chaz in forum Motor Drivers & ControllersReplies: 9Last Post: 14-01-2017, 08:41 PM -
PSU question
By iforeman in forum General ElectronicsReplies: 6Last Post: 23-11-2016, 10:56 PM -
question ...
By Wobblybootie in forum General DiscussionReplies: 6Last Post: 04-01-2010, 12:04 AM -
A question
By bodgeitandscarper in forum Gantry/Router Machines & BuildingReplies: 7Last Post: 02-12-2009, 08:30 AM
Bookmarks