Mach3 Screensets

[Ger21]

"Full Functionality" would depend on the users needs. And there are 1 port, 2 port, and 3 port breakout boards. The UB1 uses 3 of the ports.
http://www.cncroom.com/interface-cards/uc300eth-ub1

You don't need the 5LPT board with the UB1, so you save a few bucks there.

Makes sense now, I still prefer the CSMIO if not just for its "completeness" and rugged build.

But it relies on flawed software, which is the main issue.

[Davek0974]

But it relies on flawed software, which is the main issue.

Yes its one drawback and i have worked around it, I guess i could ask CSLABS if they have done anything on it as the linked stuff was a while back, doubtful though which is a pity IMHO.

[Neale]

I guess i could ask CSLABS if they have done anything on it

About as likely as retrofitting the dual-motor support from the IP-S into the IP-M, more's the pity.