welding steel base or just getting aluminium extrusion

[reefy86]

if only you could get the steel this clean lol, anyways i know i did this all before but ive done a few tweaks but i am a little concerned with the gantry side plates being so wide and because the aluminium gantry beam is pushed to the back it leaves a large space on the flange plates. this is because i was reading about not having the z axis over hanging and to have the gantry side plates in front of the z axis.

I have gone with 100x100x5mm all round for the frame
all plates are 20mm thick aluminium
linear rails 25mm
ballscrews r2010 driven on both sides with nema 23's 4nm and a rotating ball nut due to long 3000mm ballscrews

still thinking for the rest but whats your thoughts?