The main gain was in Y-axis bearings.

They are adjusters. When they are tight, there is no noticeable flex/movement on the gantry. I tighten til they stop, then quarter turn to nip up. Gantry feels rock hard.

When I loosen the grub screws, the gantry flexes as if it's on rubber mounts. Difference is remarkable.

I'm just left with the flexing of the 20mm unsupported x-axis shafts. There's a youtube video where the guy replaces them with supported rails, but improvement was MINIMAL at best. Waste of time.

I have a better, cheaper and easier solution. Just sketching out the plan and I'll post it.