Uccnc hdbb2 wiring help needed

[the great waldo]

Well I'm getting to grips with the HDbb2 board wired up a stepper power supply the Leadshine em705 drivers and the bob. The motor did what it was supposed to do went round. When I pushed the velocity settings up on the motor the driver stalled into red light error. I could only reset the drivers by turning the power on and off. Would I be correct in assuming that the drivers could be reset with the FLT+ or - connection. If i'm right where would I connect this to the bob ? Any help gratefully accepted.

Cheers
ANdrew

[m_c]

FLT is an output signal.
If you want to reset the drives without having to cycle power, you have to use the enable signal, and configure the drives via software to reset on enable.

[the great waldo]

Hi M_C

Would that be the ENA+ or - connection on the 705 ? or would that be in the uccnc software. There is a reset input on pins 23-24 and error I/O on pins 21-22 on the hbbb2 board could I use those connections. The instructions on the hdbb2 board are not very Wally friendly.

Cheers

Andrew