Thread: Uccnc hdbb2 wiring help needed
Threaded View
-
17-12-2017 #13
Last Activity: 5 Hours Ago
FLT is an output signal.
If you want to reset the drives without having to cycle power, you have to use the enable signal, and configure the drives via software to reset on enable.Avoiding the rubbish customer service from AluminiumWarehouse since July '13.
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
UCCNC MyProbe error
By chipxx in forum CNCdrive (UCCNC)Replies: 0Last Post: 22-08-2017, 02:36 PM -
Schneider Altivar 320 wiring / setup help needed
By TadasM in forum Spindles & Drive MotorsReplies: 31Last Post: 21-10-2016, 07:43 AM -
UCCNC and Rodocutter X4 Problems
By RusticRusty in forum Gantry/Router Machines & BuildingReplies: 9Last Post: 06-06-2015, 09:01 PM -
PSU wiring help needed
By Boyan Silyavski in forum General ElectronicsReplies: 7Last Post: 25-06-2014, 11:46 AM -
Driver wiring advice needed...
By Wal in forum General ElectronicsReplies: 17Last Post: 09-06-2014, 06:11 PM
Bookmarks