Thread: Uccnc hdbb2 wiring help needed
Threaded View
-
17-12-2017 #14
Last Activity: 10 Hours Ago
Hi M_C
Would that be the ENA+ or - connection on the 705 ? or would that be in the uccnc software. There is a reset input on pins 23-24 and error I/O on pins 21-22 on the hbbb2 board could I use those connections. The instructions on the hdbb2 board are not very Wally friendly.
Cheers
Andrew
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
UCCNC MyProbe error
By chipxx in forum CNCdrive (UCCNC)Replies: 0Last Post: 22-08-2017, 02:36 PM -
Schneider Altivar 320 wiring / setup help needed
By TadasM in forum Spindles & Drive MotorsReplies: 31Last Post: 21-10-2016, 07:43 AM -
UCCNC and Rodocutter X4 Problems
By RusticRusty in forum Gantry/Router Machines & BuildingReplies: 9Last Post: 06-06-2015, 09:01 PM -
PSU wiring help needed
By Boyan Silyavski in forum General ElectronicsReplies: 7Last Post: 25-06-2014, 11:46 AM -
Driver wiring advice needed...
By Wal in forum General ElectronicsReplies: 17Last Post: 09-06-2014, 06:11 PM
Bookmarks