Aluminium Extrusion Router Build

[NFryer]

Just a little follow up to my last post, I've fastened a couple of aluminium pieces to the underside of the control box and I have made a couple of top mounts for it as well.



I've also made a good start on the control panel which goes in the control box, most of the power wiring is complete. I think this is turning into a small project all of its own.




Sent from my iPhone using Tapatalk

[routercnc]

Just a little follow up to my last post, I've fastened a couple of aluminium pieces to the underside of the control box and I have made a couple of top mounts for it as well.



I've also made a good start on the control panel which goes in the control box, most of the power wiring is complete. I think this is turning into a small project all of its own.




Sent from my iPhone using Tapatalk

Looking great Nick 👍
I seem to remember my control box taking much longer than expected too !

[pheonixtech]

A massive well done on the build! I was on the point of giving up on my build due to lack of tools to finish the job properly, but this thread has given me new inspiration! Can't wait to see videos of yours running! Keep up the good work!