Threaded View
-
13-12-2017 #3
Last Activity: 26-10-2020
Thanks Phill05.
I have now checked the settings and can't see anything striking.
I have now run a small cutout pocket created in MakerCam. This runs fine, so my attention I think is the post processor in VCarve.
Anyone running VCarve or Cut2D I would be interested in knowing what Post processor you are using.
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Looking for an CNC xPro controller board
By centurian in forum Spindles & Drive MotorsReplies: 21Last Post: 21-09-2018, 10:03 PM -
VCarve pro problem?
By D-man in forum VectricReplies: 3Last Post: 23-08-2015, 07:49 PM -
vcarve pro 7
By GeoDurie in forum CAD & CAM SoftwareReplies: 3Last Post: 22-05-2014, 02:46 PM -
Motor controller next to break out board?
By m_c in forum General ElectronicsReplies: 2Last Post: 17-11-2010, 01:56 PM -
Controller Board Getting Very Hot / Allegro A3977
By MikeVA in forum Motor Drivers & ControllersReplies: 11Last Post: 08-09-2008, 03:04 AM
Bookmarks