. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 14-12-2017 #7
    Neale's Avatar
    Lives in Plymouth, United Kingdom.
    Neale
    Last Activity: 1 Day Ago Has been a member for 9-10 years. Has a total post count of 1,740. Received thanks 297 times, giving thanks to others 11 times.
    Interesting. I have Cut3D, VCarve, and PhotoVcarve all installed, and even had two versions of VCarve (8.5 and 9) installed at the same time. Never seen any problems. Some kind of fluke corruption during installation? Haven't tried Cut2D, though.
    Last edited by Neale; 14-12-2017 at 03:32 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Looking for an CNC xPro controller board
    By centurian in forum Spindles & Drive Motors
    Replies: 21
    Last Post: 21-09-2018, 10:03 PM
  2. VCarve pro problem?
    By D-man in forum Vectric
    Replies: 3
    Last Post: 23-08-2015, 07:49 PM
  3. vcarve pro 7
    By GeoDurie in forum CAD & CAM Software
    Replies: 3
    Last Post: 22-05-2014, 02:46 PM
  4. Motor controller next to break out board?
    By m_c in forum General Electronics
    Replies: 2
    Last Post: 17-11-2010, 01:56 PM
  5. Controller Board Getting Very Hot / Allegro A3977
    By MikeVA in forum Motor Drivers & Controllers
    Replies: 11
    Last Post: 08-09-2008, 03:04 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules