. .

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. 21-12-2017 #1
    magicniner's Avatar
    Lives in Rotherham, United Kingdom.
    magicniner
    Last Activity: 05-05-2024 Forum Superstar, has done so much to help others, they deserve a medal. Has been a member for 9-10 years. Has a total post count of 2,021. Received thanks 230 times, giving thanks to others 42 times.
    Air blast is better for getting chips out of slots and producing neater cuts, single flute end mills are fantastic in plastic where a deep slot is required.
    You think that's too expensive? You're not a Model Engineer are you? :D
    Reply With Quote Reply With Quote
  2. 27-12-2017 #2
    Jools's Avatar
    Lives in Lincoln UK, United Kingdom.
    Jools
    Last Activity: 22-07-2023 Has been a member for 7-8 years. Has a total post count of 31.
    Thanks guys, I'll give it a try at the speeds you've said and see what results I get.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Milling Plastazote LD33 closed cell Foam - Any milling advice?
    By Zeeflyboy in forum General Discussion
    Replies: 17
    Last Post: 06-04-2022, 10:12 PM
  2. Milling aluminium advice needed
    By zxrjohn14 in forum General Discussion
    Replies: 8
    Last Post: 08-11-2017, 02:18 PM
  3. Advice needed on everything
    By chrisjames in forum General Discussion
    Replies: 12
    Last Post: 11-11-2015, 11:40 PM
  4. VMC Tooling Advice Needed!
    By cncJim in forum Milling Machines, Builds & Conversions
    Replies: 16
    Last Post: 03-09-2014, 09:17 AM
  5. First steps, advice needed
    By Wobblycogs in forum Gantry/Router Machines & Building
    Replies: 6
    Last Post: 02-11-2012, 02:30 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules