Thread: AndyUK's Build - 1.2x1.0m Gantry
Threaded View
-
26-12-2017 #11
Or if you buy it from KJN they'll tap the ends for a couple of quid if you're lacking taps and I remember I think it was alex had issues until he got the right tap then it was super easy.
I never tapped the extrusion I used an impact driver to force the M12 bolts into the extrusion, I used corners and T nuts to keep the extrusion straight (My frame is 9045) but the gantry I recessed the aluminium into the aluminium plates by 5mm each side (20mm thick plates) which kept the gantry straight whilst I bolted it on.
I got the Hiwin recess wrong so I ended chopping 1.5cm off the Hiwin's which when I checked the Cad model was obviously wrong lol I must have been having a moment.
Hiwin's are rated for 95%+ of their loading capacity when mounted sideways on this is why on my machine I mounted the Hiwin's where the ballscrew is on yours and the ballscrew when you have the hiwins.
Removes triangles considerably simplifies the build but increase gantry plate height which can be an issue with flex. I'm only cutting wood and I made my gantry mounts 20mm thick so I don't think this is a problem for me. If and when I build again I'm going to build it same way I did before but undersling the ballscrew so it's out of way of any debris.
I have to say the No.1 thing I would do differently is rotating ball nut but if not then 10mm pitch ballscrews my router is very close in size to yours my travel is 130cm*70cm but I got 5mm pitch ballscrews and this is the biggest mistake I made on my build. (If you exclude me blowing up 1 PSU lol)
As for electronics I went with 4 AM882 (£240 new from China, Toroidal transformer for 70v (£80 from Rapid), $5 BOB for control with a PC parallel port and linuxcnc. I do intend to add an 7i73 board (allows me to use ethernet to breakout boards instead of PP) but I would say the setup I have is the bear minimum for a decent router. Stall protection being the bare minimum in a stepper driver.
Good luck with your build.Last edited by Desertboy; 26-12-2017 at 02:16 PM.
http://www.mycncuk.com/threads/10880...60cm-work-area My first CNC build WIP 120cm*80cm
If you didn't buy it from China the company you bought it from did ;)
Thread Information
Users Browsing this Thread
There are currently 11 users browsing this thread. (0 members and 11 guests)
Similar Threads
-
BUILD LOG: 8x4 router build. Steel base & Aluminium gantry gantry
By D-man in forum DIY Router Build LogsReplies: 57Last Post: 13-12-2019, 10:43 AM -
BUILD LOG: Build Log: 4'x4' Moving Gantry CNC Router
By GeorgeW21 in forum DIY Router Build LogsReplies: 14Last Post: 20-01-2019, 09:33 AM -
BUILD LOG: Ar last!!! Started my Gantry 3-Axis CNC Build
By MikeyC38 in forum DIY Router Build LogsReplies: 74Last Post: 16-06-2018, 11:29 PM -
Any sugestions how to build my gantry
By masinecc in forum Gantry/Router Machines & BuildingReplies: 8Last Post: 20-09-2015, 05:17 PM -
BUILD LOG: Flying Gantry Build Diary
By geoff.sim in forum DIY Router Build LogsReplies: 8Last Post: 29-05-2008, 02:53 AM
Bookmarks