AndyUK's Build - 1.2x1.0m Gantry

[AndyUK]

Like that thinking! What make and model 3D printer are you using?

Thanks Andy :) We're using a Creality CR10-S. Was printing accurately with PLA within an hour of opening the box - very pleased with it so far.

Personally I would brace roughly the bottom half of the side frames (sorry about negating those bottom drilled holes for the adjustable bed. Eek!)

So we're on the same page, I guess you're talking about adding the red lines in the diagram below, rather than the green? I suppose if they were removable bracing they wouldn't foul the adjustable bed permanently... I was hoping to use the lower sections of the frame for a second structure, like a coolant trap or something.