AndyUK's Build - 1.2x1.0m Gantry

[JAZZCNC]

Thanks Dean :)

Interesting to know it doesn't look like 10m/min, I'll try measuring the speed. Haven't verified the steps per yet, I'm merely going off the theory. Steppers are 1.8° per step, 8x microstepping, 10mm pitch screw, set to 160 steps per unit, jogging at 100% (although granted I could be using the UCCNC software incorrectly!)

Well that's all correct going by the numbers(provided the MS are correct on drives) so could just be the video but quick measure will verify if it is or not.