Threaded View
-
04-02-2018 #10
On that note, I do have 6 partially made rotating nut assemblies left over. I never seem to get round to finishing them, so if DesertBoy is keen then it's a cheapish way forward. I've made the motor mounts and partially made the bearing mounts (bored both bearings and center). Shafts need making. I've got the pulleys in stock. I notice we're both in Leicester...
Last edited by Jonathan; 04-02-2018 at 06:51 PM.
Thread Information
Users Browsing this Thread
There are currently 3 users browsing this thread. (0 members and 3 guests)
Similar Threads
-
WANTED: Supported rail - a couple of lengths of any size for an experiment!
By GND in forum Items WantedReplies: 0Last Post: 29-11-2016, 02:16 PM -
NEW MEMBER: Hi,Friend,I'm a B2C seller from China for ballscrew,linear guide,linear shaft etc.
By yvesleeok in forum New Member IntroductionsReplies: 11Last Post: 10-08-2013, 11:15 AM -
ballnut housing and floating end ballscrew assembly
By dsc in forum Lead Screws, Nuts & SupportsReplies: 12Last Post: 12-07-2013, 08:22 AM -
Linear rail and ballscrew dimensioning for R/C router
By CarlNicholasCarlsson in forum Linear & Rotary MotionReplies: 0Last Post: 24-03-2013, 06:52 PM -
Using SBR12 as ballscrew end support
By Lovre in forum Lead Screws, Nuts & SupportsReplies: 12Last Post: 13-12-2012, 08:52 PM
Bookmarks