Small CNC for guitar inlay work - general thoughts

[Neale]

A common fact is that people start out by buying/building a machine to suit their immediate needs, and then realise that they can do so much more now that they have that capability. Or, at least, they could do more if only the machine were just a little bigger/stronger/more accurate/faster...

A friend bought a Chinese machine (fortunately, one of the better ones) to "just" do some engraved lettering on the products he makes. Then he realised that those products could be made better/cheaper/easier/faster by incorporating the router into the build process. Then he found that he could start making items for sale that he just could not do before.

Chris above points out more ambitious uses of a CNC router in guitar making; it might be worth looking at the whole of the process to see if that points towards a different target machine or design for home building. Within reason, a big machine can do small jobs as well, but a small machine is always a small machine.

[fwm891]

Chris / Neale, Thanks for your thoughts.

I know Chris is into solid body Telecaster guitars and having built similar using a hand router to cut pick-up slots, cable channels etc I can see where he's coming from on this. I build acoustic hollow bodied guitars (though I have hand carved front and back plates on a 17" archtop jazz guitar (https://milsomguitars.weebly.com/archtop.html)), so my need to carve out large quantities of material doesn't really exist.
I initially started looking at the Chinese 3020 / 3040 machines on *bay before I joined this group. What put me off was the comments high lighted again by Chris about how good/bad these machines can be. Then after joining I started reading some of the re-build threads on the Chinese machines...
Clive S pointed me towards Wal and seeing his self build in action made me think more about going on the self build route.

I'm currently researching materials (ali extrusions, lead screws, bearings, motors... etc) No money commited yet!!

Thanks again your points are noted and perhaps I will look again at the Chinese machines in a more informed light but I think the 6040 will be beyond my current budget especially if I have to factor in replacements before I really get going.
Cheers

Francis

[JAZZCNC]

Thanks again your points are noted and perhaps I will look again at the Chinese machines in a more informed light but I think the 6040 will be beyond my current budget especially if I have to factor in replacements before I really get going.
Cheers

Francis

Francis Don't even entertain the Chinese machines they are just hassle waiting to bite you. Like Clive mentioned these small cutters require rock solid machine and the chinese machines are just not strong enough and soon go sloppy.

Either DIY build or save and buy better machine.

[fwm891]

Transferred from my Hi from Hereford thread:

Hi folks, I've been doing a few things: looking at commercial desktop machines and how they go together, looking at build threads and how they evolve, looking at some of the rebuild of the Chinese stuff and doing some parts costing. Initially looked at linear bearings and tracks for the Y & Z axii, motors, lead screws etc., even though I'm looking at a quite small machine the cost is rising sharply. Sharply enough for me to look as supported rails rather than linear bearings/tracks. Not looked at the electronics yet. All part of the learning process, I need to take more time. I was hoping to get this project going quite quickly but I think it will be a few months before I pull all the bits together ready for assembly.

I'll put some of my drawings up for discussion over the next few days to see if my thinking is in the right direction. Still looking at a fixed gantry with moving bed. Twin support rails under the bed (Y) and across the X axis and paired rails on the Z axis...

Not decided yet on the type (diameter or pitch) of lead screw for each axis but decided not to use toothed belt drives.

Cheers
Francis