Threaded View
-
24-08-2019 #18
Last Activity: 1 Hour Ago
Ok, got it to work.
The PID values in Mach 3 are not nearly transferable, wiped them to zero, enabled the drive, disabled commands to it, ran auto tune for all 3 axis.
What's strange at the moment is the fact that I cant run a programme whilst the MPG is enabled.
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
looking for a pendant to work with Cslabs ip-m mach 3
By charlieuk in forum CS-Lab (CSMIO)Replies: 7Last Post: 22-09-2017, 03:56 PM -
Any experience or software for Control Techniques FNC4? Wha do I replace it with?
By mitip in forum Motor Drivers & ControllersReplies: 15Last Post: 05-01-2016, 08:52 AM -
Spindle on/off under CNC software control - safety worries!
By HankMcSpank in forum Machine Control SoftwareReplies: 13Last Post: 12-02-2013, 03:47 AM -
Newbie. Questions about design software and machine control software
By MTech in forum Computer SoftwareReplies: 2Last Post: 11-12-2012, 12:58 PM -
servo control vs stepper control
By Peter. in forum Motor Drivers & ControllersReplies: 24Last Post: 17-09-2012, 08:36 AM
Bookmarks