-
22-02-2021 #31
-
22-02-2021 #32
-
The Following User Says Thank You to Hood For This Useful Post:
-
22-02-2021 #33
I did have a reply from CS Labs today regarding my issue of not being able to connect to the IPA and was told I needed to update the firmware -
To use simCNC you need CSMIO firmware v3.xxx.
Update the firmware to see your MAC address.
I did but from my old PC running Win XP using the boot loader v3.6 it worked fine but I still couldn't connect to the IPA with my new PC which is running WIN 10.
Very confused is it because of any security settings within Win 10 or something else ?
Hood My unit is FP 4-10.
To clear up any confusion
I bought my mill already converted and it came with a PC running Win XP and Mach 3 which is ok but the PC is very old and has frozen a few times so rather than wait for it to go wrong I would rather get it changed.
It just so happened I had a decent one doing nothing it has an AMD Ryzen 5 3400G Processor 16Gb Ram and a PCIE SSD more than needed for Sim CNC.Last edited by Eatonm62; 22-02-2021 at 08:44 PM.
-
28-07-2021 #34
Sorry to bring an old thread back from the dead, but seemed to be the logical place to post.
I finally finished my upgrade to an IP-A, but need to add controls in the SimCNC software for a second spindle.
I'd like to use M13/14/15 and can see I need to add the M code macros, and also assign in Device script, but can't see how to tie that to the relevant outputs.
Does anyone have an idea how this may be achieved?
regards, Oz
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
looking for a pendant to work with Cslabs ip-m mach 3
By charlieuk in forum CS-Lab (CSMIO)Replies: 7Last Post: 22-09-2017, 03:56 PM -
Any experience or software for Control Techniques FNC4? Wha do I replace it with?
By mitip in forum Motor Drivers & ControllersReplies: 15Last Post: 05-01-2016, 08:52 AM -
Spindle on/off under CNC software control - safety worries!
By HankMcSpank in forum Machine Control SoftwareReplies: 13Last Post: 12-02-2013, 03:47 AM -
Newbie. Questions about design software and machine control software
By MTech in forum Computer SoftwareReplies: 2Last Post: 11-12-2012, 12:58 PM -
servo control vs stepper control
By Peter. in forum Motor Drivers & ControllersReplies: 24Last Post: 17-09-2012, 08:36 AM
Bookmarks