Thread: Sieg C3 backlash problem
Hybrid View
-
07-09-2009 #1
I have fitted these kits in the past and I'm sure they are adjustable.
I think I may still have the bits to one kicking around because I bought a C3 two years ago but seem to have misplaced it somewhere.
Last I saw it was still in a big wooden packing case but can't recall seeing it lately [ note to self - check Tardis No 2 # ]John S -
-
07-09-2009 #2
-
07-09-2009 #3
Don't recall seeing any instructions, mind you when I find the bits they will have been kicking around for so long that if there were any they would have gone walkabout.
I have fitted these to a few things and can't remember having problems but then again i may have adjusted any play out.
I fitted a set to a Taig mill, they go nearly straight on because these things work on 20tpi screws.
They are just an encoder that counts based on 20.John S -
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Is this an example of what backlash can do?
By Minnican in forum Machine DiscussionReplies: 19Last Post: 06-03-2011, 08:59 PM -
backlash mack3
By h4ppy-chris in forum General DiscussionReplies: 9Last Post: 29-01-2011, 01:11 PM -
Sieg X3 backlash...
By Vikash in forum General DiscussionReplies: 0Last Post: 20-10-2010, 02:51 PM -
Positive backlash???
By fasteddy in forum Gantry/Router Machines & BuildingReplies: 3Last Post: 18-08-2010, 05:04 PM -
Commercial Sieg X1 anti backlash nuts ?
By cweeks in forum Milling Machines, Builds & ConversionsReplies: 0Last Post: 28-05-2009, 06:41 PM
Bookmarks