Thread: NCStudio Z Axis Limit Reached
-
12-02-2018 #1
Morning Everyone,
Today I've set up my bed and I had previously had thinner wood on the bottom as a temp spoil board while I waited for my actual board I was using for my spoil board.
As I've set it all up and clamped it to the bed, I thought it was going to well.
Loaded up NCStudio - set my work piece origin then tried to do my "Z axis" with the mobile calibrator.
It completes only to jump up to the highest point and flash a red warning in the NCStudio window.
(I know how to fix this by disabling the limits and pressing 1)
My understanding was that it will always jump back to 10 mm regardless of the thickness of wood I used after using the mobile calibrator?
(Edit: But it only jumps back up to 8.2xxx and then gives me the error)
So my question is this; How can i check where the Z axis is set to? and any other trouble shooting tips anyone has would be greatly received.
T.I.A
JoshLast edited by Josh_BCF; 12-02-2018 at 12:33 PM. Reason: more info is always good
-
16-02-2018 #2
FYI - my drill bit was sticking out too far....
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Need a copy of Ncstudio .....win xp plz
By Cooperuter in forum Chinese MachinesReplies: 0Last Post: 26-04-2016, 06:04 AM -
EMC2 home/limit switches... only acting as limit?
By vputz in forum LinuxCNC (EMC)Replies: 4Last Post: 15-10-2014, 09:51 AM -
One limit switch per axis
By EddyCurrent in forum General ElectronicsReplies: 17Last Post: 30-09-2013, 11:38 AM -
FOR SALE: Z axis with Home/limit switch and Nema 23 3nm
By Shinobiwan in forum Items For SaleReplies: 6Last Post: 02-02-2013, 10:54 AM -
NCStudio or Mach 3 or something else?
By Fivetide in forum Machine Control SoftwareReplies: 7Last Post: 01-09-2012, 05:41 PM
Bookmarks