. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 12-02-2018 #2
    johngoodrich's Avatar
    Lives in st austell, United Kingdom.
    johngoodrich
    Last Activity: 04-08-2022 Has been a member for 9-10 years. Has a total post count of 216. Received thanks 14 times, giving thanks to others 1 times.
    well going by cutwels data they recommend 6300rpm and 280mm/min so I think you are going much too fast for it.
    https://www.cutwel.co.uk/FileDeposit...ta%20E2752.pdf
    is there any reason you are using a ripper for it? I would personally use a 3 flute carbide end mill with the same doc and speed but about 1500mm/min. I use a lot of these:
    https://www.shop-apt.co.uk/3-flute-c...-45-helix.html
    Reply With Quote Reply With Quote

  2. The Following User Says Thank You to johngoodrich For This Useful Post:

« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Help with speeds/feeds please?
    By examorph in forum Tool & Tooling Technology
    Replies: 5
    Last Post: 29-01-2017, 01:54 PM
  2. Speeds and feeds
    By eurikain in forum Workshop & Equipment
    Replies: 3
    Last Post: 26-03-2016, 06:00 PM
  3. Feeds and speeds software
    By suesi34e in forum Swarf & Chip Management
    Replies: 4
    Last Post: 22-03-2016, 10:30 PM
  4. Feeds and speeds
    By dudz in forum Tool & Tooling Technology
    Replies: 0
    Last Post: 26-08-2013, 11:42 AM
  5. Speeds and Feeds
    By Web Goblin in forum Tool & Tooling Technology
    Replies: 0
    Last Post: 20-09-2012, 01:38 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules