Denford Cyclone -turret positioning error

[Dangle_kt]

Thanks, I'll use a trusty multimeter (very carefully) to figure it out

[Dangle_kt]

here is a little video of the back of the lathe which has a hand written note the turret is called TPFT, any help pointing me at a schematic?

https://www.youtube.com/watch?v=PW7XRpv4oGg

[Dangle_kt]

I called up a CNC repair place yesterday, and they suggested removing the panel off the turret, winding it on manually with an allen key, and depressing the pin to get it to seat - they also mentioned the phases being incorrect.

Going to look at the phases first, and then will give the machine a good clean before opening anything up